Honeywell 013046 Mounting Instructions page 2

Mounting Instructions
Case back flush mount
Item no. 013046 (white)
Item no. 013047 (gray)
Item no. 013048 (black)
suitable for:
- LED Keypad for MB-Secure
- LED/LCD Keypad for MB-Secure
- Touch operating module
TouchCenter plus
- FM Frame for TC plus, Item no. 013051
Mounting
Wall recess:
Prepare a wall recess with dimensions 208 x 152 mm.
Total depth at least 30 mm.
Ensure that the recess is no larger than the external
dimensions of the edge (218 x 162 mm).
Preparation for a TouchCenter plus
- Disengage the 4 retaining connectors.
- Remove cover contact actuation/tear-off protection for
LED and LED/LCD Keypad 3.
- Completely screw in
TouchCenter plus) with
- Now unscrew adjusting screw till the cover contact is
audibly actuated when the TouchCenter plus is inserted into
the case back.
Claw fasteners for installation in cavity walls:
- Position claw fasteners as shown in diagram.
- Screw in till claw fasteners are firmly in place.
- Place housing in the cavity wall.
- Tighten screws. The claw fasteners rotate by 90°.
- Tighten screws till the housing is securely fastened.
30
1
2
:
adjusting screw 6 (Accessory
an appropriate tool .
1
3
1
7
1
1
To bring out the cable inlets, place the screw diver in
the center and pivot them out.
Captions:
1 Mounting system to fix claw fasteners or
connection elements (see below)
2 Cable inlets
3 Cover contact actuation for LED and LED/LCD
Keypad
4 Retaining connectors
5 Cover contact actuation for
6 Adjusting screw for cover contact actuation
(Accessory TouchCenter plus)
7 Pull relief holder for cable ties
Array flush-mounted case backs:
Flush-mounted case backs that have been arrayed
(horizontally and/or vertically) must be mounted with
correct spacing.
- Insert connection elements in the mounting system
from rear to front, as shown in the diagram.
- Screw in and tighten moderately.
218
208
1
4
7
5
6
1
TouchCenter plus
1
1