Input Capture Data Registers (Ipcph0 To Ipcph3, Ipcpl0 To Ipcpl3) - Fujitsu MB91260B Series Hardware Manual

CHAPTER 11 MULTIFUNCTIONAL TIMER
11.4.8 Input Capture Data Registers
(IPCPH0 to IPCPH3, IPCPL0 to IPCPL3)
The input capture data register is used to store the count value of the free-run timer on
detection of a valid edge for the input waveform.
■ Input Capture Data Register (IPCPH: IPCPH0 to IPCPH3, IPCPL: IPCPL0 to IPCPL3)
Input capture data register (Upper)
IPCPH0 to IPCPH3
Address :
0000AC
H
0000AE
H
0000B0
H
0000B2
H
Input capture data register (Lower)
IPCPL0 to IPCPL3
This register is used to store the value of the free-run timer on detection of a valid edge for the
corresponding external pin input waveform. (To access this register, use a halfword or word access
instruction. Data cannot be written to this register.)
236
Bit15 Bit14
CP15 CP14
Read →
R R
Initial value →
(X) (X)
Bit7 Bit6
CP07 CP06
Read →
R R
Initial value →
(X) (X)
Bit13 Bit12 Bit11
CP13 CP12 CP11
R R R
(X) (X) (X)
Bit5 Bit4 Bit3
CP05 CP04 CP03
R R R
(X) (X) (X)
Bit10 Bit9 Bit8
CP10 CP09 CP08
R R R
(X) (X) (X)
Bit2 Bit1 Bit0
CP02 CP01 CP00
R R R
(X) (X) (X)