English
(2)
If the fi gures on the display and positive
stop still do not match, then return the
turntable to the 0° position. Next move the
turntable left and right with the side handle
loosened as shown in Fig. 24-b. After
setting it to the correct position 0°, press
the reset button again as shown in Fig. 23
on page 69.
PRACTICAL APPLICATIONS
WARNING
To avoid personal injury, never
○
remove or place a workpiece on the
table while the tool is being operated.
Never place your limbs inside of
○
the line next to warning sign while
the tool is being operated. This may
cause hazardous conditions (see Fig. 25).
1.
Switch operation (Fig. 26)
Pull the trigger to turn on the switch, release it to
shut it off .
After releasing the trigger, make sure the trigger
has gone all the way back and the switch is
turned off .
2.
Using the Vise Assembly (Standard accessory)
(1)
The vise assembly can be mounted on
either the left fence {Fence (B)} or the right
fence {Fence (A)} by loosening the 6 mm
wing bolt (A).
(2)
The screw holder can be raised or lowered
according to the height of the workpiece by
loosening the 6 mm wing bolt (B). After the
adjustment, fi rmly tighten the 6 mm wing
bolt (B) and fi x the screw holder.
(3)
Turn the upper knob and securely fi x the
workpiece in position. (Fig. 27)
Move the turntable left and right with
the side handle loosened and set it to
the correct position.
Line
Warning sign
6 mm wing bolt (B)
Fence
Vise shaft
6 mm wing bolt (A)
70
Side handle
Turntable
Fig. 24-b
Warning sign Line
Fig. 25
Trigger switch
Fig. 26
Screw holder
Knob
Vise plate
Workpiece
Fig. 27