Optional Accessories (Sold Separately); Applications; Prior To Operation - Hitachi H 60ME Handling Instructions Manual

OPTIONAL ACCESSORIES (sold separately)

Demolishing
○
(1) Bull Point
Overall Length: 280, 400 mm
Surface Roughing
○
(1) Bushing Tool
Groove digging and edging
○
(1) Cold chisel
Overall length: 280, 400 mm
○ Hammer Grease A
500 g (in a can)
70 g (in a tube)
30 g (in a tube)

APPLICATIONS

Breaking concrete, chipping off concrete, grooving, bar cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility installation, machinery installation, water supply
and drainage work, interior jobs, harbor facilities and other civil engineering work.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to the power requirements specifi ed
on the product nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle
while the power switch is in the ON position, the power tool will start operating immediately,
which could cause a serious accident.
3. Extension cord
When the work area is removed from the power source, use an extension cord of suffi cient
thickness and rated capacity. The extension cord should be kept as short as practicable.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired.
○
○
(2) Shank
○
23
Asphalt Cutting
(1) Cutter
Tamping
(1) Rammer
Scooping Work
(1) Scoop
English
(2) Shank