USB
Tuner record timer setting
This function enables you to set a timer for
starting and stopping ripping from the tuner
source automatically.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
1
Tune to the station you desire to record from.
(See "Radio Reception": "Tuning to radio stations"
and "Tuning to preset radio stations".).
2
Go to the standby mode. Then, press and hold
SLEEP/TIMER on the remote control for
more than two seconds to select timer mode.
➜
The last timer setting starts flashing.
➜
The selected source will be lighted.
3
Press TUNER to select TUNER mode.
4
Press USB RECORD to enable USB recording.
➜
"ST" appears. "USB REC" and the hour and
minute digits for the start timer start flashing.
●
To cancel USB record setting, press USB
RECORD again until "ST" and "USB REC"
disappear.
➜
In this case, you can only continue to set the
system switch-on timer. (See "Clock/Timer":
"Timer setting".)
5
Press ALBUM/PRESET -/+ (or ALBUM -/+
(à / á) on the remote control) repeatedly to
set the hour for the timer to start.
6
Press S / T (or TITLE -/+ (í /ë) on
the remote control) repeatedly to set the minute
for the timer to start.
7
Press SLEEP/TIMER on the remote control to
confirm.
➜
"ET" appears.
digits for the sleep timer (12 hours later than the
start timer by default) star t flashing.
8
Press ALBUM/PRESET -/+ (or ALBUM -/+
(à / á) on the remote control) repeatedly to
set the hour for the timer to stop.
9
Press S / T (or TITLE -/+ (í /ë) on
the remote control) repeatedly to set the minute
for the timer to stop.
0
Press SLEEP/TIMER on the remote control to
store the set tuner record timer.
➜
The ripping will start at the set start time and
end at the set stop time.
24
and the hour and minute
Notes:
– It is impossible to set a sleep timer more than
12 hours later than the start timer.
– During timer setting, if no button is pressed
within 60 seconds, the system will exit timer setting
mode automatically.
To deactivate the TIMER
●
In standby mode, press SLEEP / TIMER on the
remote control.
➜
disappears from the display.
To activate the TIMER
●
In standby mode, press SLEEP / TIMER on the
remote control.
➜
appears on the display.