Black & Decker SC800 Manual page 4

ENGLISH
Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
Before use, check the power supply
cord for signs of damage, ageing and
wear.
Do not use the appliance if the power
supply cord or mains plug is damaged
or defective.
If the power supply cord or mains plug
is damaged or defective it must be
repaired by an authorised repair agent
in order to avoid a hazard. Do not cut
the power supply cord and do not
attempt to repair it yourself.
Never attempt to remove or replace
any parts other than those specified in
this manual.
Warning symbols
The following symbols are used in this
manual:
Do not use this appliance near
bathtubs, showers, basins or
other vessels containing water.
When the hairdryer is used in
a bathroom, unplug it after
use since the proximity of
water presents a hazard even
when the hair dryer is
switched off.
!
Denotes risk of personal
injury or damage to the
product in case of non-
observance of the instructions
in this manual.
Denotes risk of electric shock.
Electrical safety
This tool is double insulated
in accordance with EN 60335;
therefore no earth wire is
required. Always check that
the power supply corresponds
to the voltage on the rating
plate.
To avoid the risk of electric
shock, do not immerse the
4
cord, plug or motor unit in water or other
liquid.
For additional protection, the installation
of a Residual Current Device (RCD) having
a rated residual operating current not
exceeding 30mA is advisable in the
electrical circuit supplying the bathroom.
Ask your installer for advice.
Features
1. Cool shot button
2. Heat control switch
3. Speed control switch
4. Hanging loop
5. Concentrator nozzle
6. Diffuser nozzle
7. Rear cover
Assembly
Warning! Make sure that the appliance is
switched off and unplugged.
Fitting and removing the attachments
(fig. A)
Allow the appliance to cool before
changing the attachments.
Fit the diffuser nozzle ( 6) or the
concentrator nozzle ( 5 ) by pushing it
onto the outlet sleeve until it snaps into
place. Removed the item by pulling it
from the appliance.
Use
Warning! The appliance may be hot during
use and during the cool-down period.
Switching on and off (fig. B)
The speed control switch (3) has three
positions: off, slow and fast.
Move the switch to position 0 to switch
the appliance off.
Turn the switch to position 1 for
blowing air at a slow speed.
Turn the switch to position 2 for
blowing air at a high speed.
Heat control (fig. B)
The heat control switch (2) has three
positions: warm, hot and very hot.
Move the switch to position 1 for
normal warm air.