Page 2
® This manual covers all the essentials of the use and care of the AutoFlagger . It is divided into sections so that the reader may choose to read only those sections relevant to him or her. The...
Sign Head Set Up and Basic Operations After raising solar panel: • Release column brake. • Disengage transport lock. • Depress the ON button momentarily. The sign head computer will boot in about 3 seconds. • Rotate head to front position (facing traffic). •...
Page 4
SIGN HEAD RAISE/LOWER SLOW MANUAL OVERRIDE SIGN HEAD POWER PUSH ON STOP PUSH OFF MANUAL OVERRIDE COVER LOCK RING: RELEASE BEFORE LOWERING HEAD CAUTION: WHEN LOWERING HEAD, DO NOT ALLOW COVER TO CONTACT COLUMN BASE...
Page 5
Hand-Held Defaults and Set Up Options Getting Started - Defaults • Press and hold PWR button momentarily (about ½ second), then release. Allow several seconds for the computer to boot. • Select back light option. Depressing the STOP button turns the backlight OFF. Depressing either of the SLOW buttons leaves the backlight ON.
Page 6
• Both signs must be in the STOP position before either sign can be commanded to its’ SLOW position. • As a sign is changing positions, the graphics will morph as shown below. • NOTE: The auxiliary lights positioned on the sign heads display 3 distinct positions.
Example 1: to Swap Sign Sides • Depress MODE to see the following display; and use the up/down arrows to toggle between choices. UP ARROW DOWN ARROW • When ‘SWAP SIGN SIDES’ is selected, depress the ENTER key to see the following;...
Page 8
Example 2: To allow both signs to read SLOW simultaneously, ‘INDEPENDENT’ (dump truck crossing) mode • Depress the MODE key and use the DOWN ARROW key to select the ‘SET SIGN MODE’ function. • Depress the ENTER button. • Scroll down to select the ‘INDEPENDENT’ mode, then depress the ENTER button to activate that function.
Page 9
Example 4: Binding (connecting) hand-held remote control to Signs • General Overview Each hand-held transceiver and each sign head have a unique I.D. hard-coded into their microprocessors at the factory. An operator can select one or two signs and connect or bind a hand-held to them either in the yard, or on the job. The hand- held will only bind to the sign(s) assigned to it in the following procedure.
Page 10
The charger for the hand-held’s batteries (in the charging bay) draws a slight amount of power continuously. When storing the AutoFlagger inside, or in the absence of sunlight for periods of time greater than 45 days, use of a trickle charger will help keep the 12 volt deep cycle batteries charged.