No Paper Feeding From Manual Feed Slot; Multiple Sheets Of Paper Are Fed - Brother HL-2290 Service Manual

4.2.3 No paper feeding from manual feed slot

<User Check>
• Check that the paper is set into the deepest part of the manual feed slot.
• Check that multiple sheets of paper are not set in the manual feed slot.
• Check that the thickness of the paper is 60 to 230 g/m
• Check that the paper tray is not set as the pick-up tray.
• Check that the paper tray is closed correctly.
Step
1
2
3
4
5
6
7
8
9
10

4.2.4 Multiple sheets of paper are fed

<User Check>
• Check that there is not too much paper set in each paper tray.
• Check that the paper is set in each paper tray correctly.
• Flip over the paper in each paper tray or rotate the paper 180°.
• Check that the thickness of the paper is 60 to 163 g/m
and 60 to 230 g/m
• Flip through the paper and reset it in the paper tray.
Step
1
Cause
T1 roller holder ASSY
attachment failure
Connection failure of the paper
feed motor flat cable
Connection failure of the
registration front/rear sensor
harness
Abrasion of the paper pick up
roller
Paper feed motor flat cable
failure
Registration front sensor failure
Paper feed motor failure
Damaged gears in the paper
feed drive system
Damaged fuser unit
Main PCB failure
2
for the MP tray.
Cause
Abrasion of the separation pad
2
.
Reattach the T1 roller holder ASSY.
Reconnect the paper feed motor flat
cable.
Reconnect the registration front/rear
sensor harness.
Replace the PF kit 1.
Replace the paper feed motor flat cable.
Replace the actuator holder ASSY.
Replace the paper feed motor.
Replace the frame L unit.
Replace the fuser unit.
Replace the main PCB ASSY.
2
for the paper tray,
Replace the PF kit.
2-55
Remedy
Remedy
Confidential