Appendix; Display Messages - Yamaha YC Series Owner's Manual

Appendix

Display Messages

LCD indication
Auto power off disabled.
Completed.
Connecting to USB device...
Device number is off.
Device number mismatch.
File or folder already exists.
File or folder path is too long.
Illegal bulk data.
Illegal file name.
Illegal file.
Incompatible USB device.
MIDI buffer full.
MIDI checksum error.
No device.
No read/write authority to the file.
Now receiving MIDI bulk data...
Now transmitting MIDI bulk data...
Please reboot to maintain internal
memory.
Push [PANEL LOCK] Button.
Unsupported USB device.
USB connection terminated.
USB device is full.
USB device is write-protected.
USB device read/write error.
Description
This message appears when Auto Power Off is disabled.
The specified load, save, format, or other Job has been completed.
Currently recognizing the USB flash drive connected to the USB [TO DEVICE]
terminal.
Bulk data cannot be transmitted/received because the device number is off.
Bulk data cannot be received because the device numbers do not match.
A file/folder having the same name as the one you are about to save already exists.
The file or folder you tried to access cannot be accessed because the maximum amount
of characters indicating the path has been exceeded.
An error occurred while receiving a Bulk data or Bulk Request message.
The specified file name is invalid. Try entering a different name.
The specified file is unusable by this instrument or cannot be loaded.
USB device which cannot be used with this instrument has been connected to the USB
[TO DEVICE] terminal.
Failed to process the MIDI data because too much data was received at one time.
An error occurred when receiving bulk data.
Device is not connected.
Indicates that you do not have the authority to read/write the file.
Indicates this instrument is receiving MIDI bulk data.
Indicates this synthesizer is transmitting MIDI bulk data.
Reboot this instrument to restore the internal memory.
Push the [PANEL LOCK] button to disengage panel lock.
This message appears if the plugged-in USB flash drive is either unformatted or
formatted in a way that this instrument does not support. Please format the USB device
using this instrument.
Communication with the USB device has been shut down because of the overcurrent to
the USB device. Disconnect the device from the USB [TO DEVICE] terminal, and then
turn on the power of the instrument.
The USB flash drive is full and no more data can be saved. Use a new USB flash drive, or
make space by erasing unwanted data from the storage device.
This message appears when you have attempted to write to a protected USB flash drive.
An error occurred while reading or writing to/from a USB flash drive.
51
YC61 Owner's Manual