Windows Recovery (Without "Easyrestore" License Label) - Epson RC420 Manual

(13) Enter the "Product Key" recorded on the COA label attached on the front of the
(14) Input the serial number (SN*****) of the RC420 to the [Computer Name] box in the
(15) After rebooting, click the <OK> button in the [Windows Login] dialog.
(16) Windows starts.
NOTE
If the EPSON RC+ is not installed, the [Install the Robot Control Software] dialog appears
when the Controller is started. Make sure to install the EPSON RC+ in the Controller.
If it is not installed, Windows will automatically shutdown in 30 minutes.

12.1.3 Windows Recovery (Without "EasyRestore" License Label)

NOTE
When you accidentally turn on the RC420 with the Recovery startup disk in its FD drive,
the RC420 will start from the recovery startup disk. In this case, turn OFF the Controller
before the restore begins. The restore will not begin until you click the <Y> key in the
following procedure (7).
(1) Connect the PS/2 keyboard and the PS/2 mouse to the RC420.
(2) Set the recovery start up disk in to the FD drive.
(3) Turn ON the RC420.
(4) The message "USB Key Board and USB Mouse are not available. Please use the PS/2
(5) After "SKIP BAD SECTOR CHECK ?" appears, press the <Y> or the <N> key.
NOTE
RC420 Rev.9
Controller (inside the front door) in the [Product Key] dialog and click the <Next>
button.
[Computer Name and Administrator Password] dialog and click the <Next> button.
(The USB keyboard and the USB mouse cannot be used in Windows recovery.)
Key Board and PS/2 Mouse." appears. Read the message and press the <Enter> key
after "Strike a key when ready..." appears.
The time required will change by the key selection since the process changes. The
required is only a measure.
Key
Y Skip the bad sector check
N Do not skip the bad sector check
Maintenance 12. Recovering the HDD
Contents Time Required
About 4 minutes
About 45 minutes
147