Fujitsu PRIMERGY PG-RSBOP2 User Manual page 48

Chapter 2 Mounting This Product
■Mounting Position
Connect the two cables provided with this product as shown in the figure below.
To connect the cables, temporarily remove the slot protective plates and pass the cables
under the plates.
Before connecting the 3-pin power cable, remove the WOL cable connected to the
standard installation LAN card.
[Connecting the Remote Service Board]
Server control connector 4 (4-pin)
Server power supply Connector (2-pin)
6
I2C connector (3-pin)
Cable (3-core)
Power connector (3-pin)
Cable (2-core)
PCI slot 1
PCI slot 2
PCI slot 3
Slot protective plates
Remote Service Board