General Operation - Philips AZ1302/00 User Manual

English
Supplied accessories
– AC mains lead
– remote control
Right panel (See 1)
1 Source selector CD,TUNER,
TAPE/OFF
– selects CD/MP3-CD, radio or tape source
of sound
– switches off the set
2 MONO•STEREO
– selects mono or stereo FM reception
Top and front panels(See 1)
3 VOLUME – adjusts volume level
4 LIFT TO OPEN – lift here to open the
disc door
5 REMOTE SENSOR – infrared sensor for
remote control
6 Cassette recorder keys:
PAUSE ; – pauses playback or recording
STOP•EJECT 9/
– stops playback or recording.
– opens the cassette holder.
F.FWD/REW 5 or 6 – fast winds/rewinds
the tape
PLAY 1 – starts playback
REC 0 – starts recording
7 Display – shows the status of the set
8 PROG
CD/MP3: programmes tracks and reviews
the programme;
TUNER: programmes preset radio stations
9 DBB – switches the bass enhancement
on / off
0 ALBUM/PRESET -
MP3 only: selects albums (down);
RADIO: selects preset stations (down)
! SEARCH ∞ , §
CD/MP3: – searches back and forward
within a track;
– skips to the beginning of a
current track/ previous/ later
track
TUNER: tunes to radio stations.
@ STOP/BAND 9
CD/MP3: – stops playback;
– erases a programme.
TUNER: selects wavebands
Controls
# PLAY/PAUSE 2/; – starts/ pauses CD
playback
$ MODE
– selects different play modes:
e.g. REPEAT or RANDOM (random
order)
% ALBUM/PRESET +
MP3 only: selects albums (up);
TUNER: selects preset stations (up)
Back panel (See 2)
^ Telescopic antenna - improves FM
reception.
& AC ~ - inlet for mains lead
* RESET – use ball-point pen to press the
hole if the set or display does not
react to any of the controls
( p PHONES- 3.5mm stereo headphone
jack
) Battery door - open to insert 8 x 1.5V
R-14/ UM2/ C-cells.
Remote control
1 PLAY/PAUSE – starts / pauses CD
playback
2 STOP/BAND
CD/MP3: – stops playback;
– erases a programme.
TUNER: selects wavebands
3 ∞ §
CD/MP3: – searches back and forward
within a track;
– skips to the beginning of a
current track/ previous/ later
track
TUNER: tunes to radio stations.
4 MODE– selects different play modes:
e.g. REPEAT or RANDOM (ran-
dom order)
5 PROG
CD/MP3: programmes tracks and reviews
the programme;
TUNER: programmes preset radio stations
6 ALBUM/PRESET +
MP3 only: selects albums (up);
TUNER: selects preset stations (up)
7 ALBUM/PRESET -
MP3 only: selects albums (down);
TUNER: selects preset stations (down)
Power Supply
Power supply
Whenever convenient, use the mains lead if
you want to conserve battery life. Make sure
you remove the plug from the set and wall
outlet before inserting batteries.
Batteries (not included)
Main set (See 2)
•Insert 8 batteries, type R-14, UM2 or
C-cells (preferably alkaline) with the correct
polarity.
Remote control (See 2)
•Insert 2 batteries, type AA, R06 or UM3
(preferably alkaline).
Batteries contain chemical substances,
so they should be disposed of properly.
• Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to
burst:
• Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
• When inserting new batteries, do not try to
mix old batteries with the new ones.
• Remove the batteries if the set is not to be
used for a long time.
Using AC Mains
1 Check if the mains voltage, as shown on
the type plate located on the
back of the set, corresponds to your local
mains supply. If it does not, consult your
dealer or service center.
2 Connect the mains lead to the AC ~ inlet
and the wall socket.The mains lead is now
connected and ready for use.
3 To switch the set off completely, withdraw
the mains lead from the wall socket.
• Disconnect the mains lead from the wall
socket to protect your set during heavy
thunderstorms.

General Operation

Helpful hints : To avoid unnecessary energy
consumption, always adjust the Source
selector to TAPE/OFF after using the set.
Also check that the tape deck keys are
released
The type plate is located on the back of
the set.
General operation
Switching on and off and selecting
functions
1 To switch on, push the Source selector
slider to CD, TUNER, or TAPE/OFF as
desired.
➜ In CD or TUNER, the display
lights up blue.
➜ In TAPE, the display lights up
during tape operation
2 To switch off, push the Source selector
slider to TAPE/OFF and check the cassette
keys are released.
Helpful hints:
– To change from TAPE to TUNER or CD
function, or when you are switching off the set:
first, make sure you press the tape
STOP•EJECT 9/ key to end playback and
all the cassette keys are released.
– The radio presets will be retained in the set's
memory.
Adjusting volume and sound
1 Adjust the volume with the VOLUME
control.
2 Press DBB once or more to select dynamic
bass boost on or off.
This set complies with the radio
interference requirements of the European
Community.