General Information On Recording; Preparation For Recording; One Touch Recording; Cd Synchro Recording - Philips FW-P750/22 User Manual

To rewind or fast forward when playback
is stopped
1
Press à or á.
2
Press Ç when you reached the desired passage.
To reset tape counter number
G When in stop mode, pressÇ.
➜ "TP1 000" or "TP2 000" will be displayed.
Notes:
– During rewinding or fast forwarding of a tape, it
is also possible to select another source (CD,
TUNER or AUX, for example).
– The tape counter will automatically set to zero
after detecting end of tape.
General Information on
Recording
G For recording, use only tape of IEC type I
(normal tape) or IEC type II (Cr0
G The recording level is set automatically, regardless
of the position of the Volume, VAC, DSC and so
forth.
G The tape is secured at both ends with leader
tape. At the beginning and end of the tape,
nothing will be recorded for six to seven
seconds.
G To prevent accidental recording, break out the
tab on the left shoulder of the tape side you
want to protect.
G If "CHECK TAPE" is displayed, the protection
tab has been broken. Put a piece of clear
adhesive tape over the opening. Do not cover
the Cr0 tape detection hole when covering the
2
tab opening.
pg 001-031/P750/22-Eng
Tape Operation/Recording
IMPORTANT!
– Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
– Recording is possible only on tape deck 2.
– Switch off Dolby Pro Logic when
recording.

Preparation for Recording

1
Press TAPE (TAPE 1•2) to select TAPE 2.
2
Load a recordable tape into tape deck 2 with full
spool to the left.
3
Prepare the source to be recorded.
CD – load the disc(s).
TUNER – tune to the desired radio station.
TAPE – load the prerecorded tape into tape
deck 1 with the full spool to the left.
AUX – connect external equipment.
When recording is in progress
).
2
➜
G It is not possible to listen to another source
except for dubbing tapes.
G It is not possible to activate the timer function.

One Touch Recording

1
Press CD, TUNER or AUX to select the
source.
2
Start playback of the selected source.
3
Press REC to start recording.
To stop recording
G Press Ç on the system.
Note:
– One Touch Recording is not possible in TAPE
mode, "SELECT SOURCE" will be displayed.

CD Synchro Recording

1
Press CD 1•2•3 to select the disc.
G Press í or ë to select the desired track to
start recording.
G You can programme the tracks in the order you
want them to be recorded (refer to "CD
Operation - Programming the disc tracks").
2
Press REC to start recording.
➜ The disc will start playback automatically.
25
starts flashing.
3139 115 20612
3/7/01, 4:13 PM
25