Unloading The Dishwasher - Electrolux ESF 63020 User Manual

12 electrolux
During the running of the programme, it
is not possible to change the selection
made by turning the programme knob in
correspondence of another programme
or the Off position. If you want to change
the running programme you must cancel
the selection made (see "Cancel a wash-
ing programme in progress").
Setting and starting the programme with
"delay start"
• Allows the start of the programme to be
delayed by 3 hours.
1. After having selected the washing pro-
gramme, press the delay start button.
– The corresponding indicator light illu-
minates.
2. Press the start/cancel button, the count-
down of the delay start begins automati-
cally.
– The phase indicator lights turn off.
– The opening of the door will not modify
or interrupt the countdown.
– Once the delay start has elapsed the
washing programme will start auto-
matically, the delay start indicator light
turns off while the indicator light of the
phase in progress illuminates.
Cancelling the "delay start"
• Press the start/cancel button for about 5
seconds, the indicator lights of start/can-
cel and delay start buttons turn off while
the indicator lights of the phases start
flashing.
To start the selected washing programme
press the start/cancel button.
The washing programme or the count-
down of the delay start will begin only

Unloading the dishwasher

• Hot dishes are sensitive to knocks.
The dishes should therefore be allowed to
cool down before removing from the ap-
pliance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
• Water may appear on the sides and the
door of the dishwasher as the stainless
after having pressed the start/cancel
button. Until that moment it is possible
to modify the selection made.
Interrupt or cancel a washing pro-
gramme in progress ONLY if it's abso-
lutely necessary. Attention! Hot steam
may escape when the door is opened.
Open the door carefully.
Interrupt a washing programme in pro-
gress:
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
Cancel a washing programme in pro-
gress
• Press the start/cancel button for about 5
seconds. The start/cancel indicator light
turns off and the phase indicator lights are
flashing. The running programme has
been cancelled and it is now possible to
set a new washing programme or switch
off the machine. If a new washing pro-
gramme is to be selected, check that there
is detergent in the detergent dispenser.
End of the washing programme
• The dishwasher will automatically stop.
• The end of programme indicator light will
illuminate.
1. Switch off the dishwasher by returning
the programme knob to the Off position.
The On/Off indicator light turns off.
2. Open the dishwasher's door, leave it ajar
and wait a few minutes before removing
the dishes; in this way they will be cooler
and the drying will be improved.
steel will eventually become cooler than
the dishes.
Caution! When the washing
programme has finished, it is
recommended that the dishwasher is
unplugged and the water tap turned off.