Tune To Fm Radio Stations; Plug & Play; Program Radio Stations Automatically; Program Radio Stations Manually - Philips MCD263/78 User Manual

7 Tune to FM
radio stations
Note
•
Ensure that you have connected and fully
extended the supplied FM antenna.
Plug & Play
When you connect the unit to the power
supply for the first time, or no radio station
is stored in this unit, Plug and Play mode is
activated to store all available radio stations
automatically.
1
Connect the unit to the power supply.
»
[AUTO INSTALL - PRESS PLAY,
STOP CANCEL] (auto install - press
the PLAY button; to cancel, press
) displays.
2
Press on the main unit to start
installation.
»
[AUTO] (auto) displays.
»
[PROG] (program) flashes.
»
The unit automatically store radio
stations with sufficient signal strength.
3
When all the available radio stations are
stored, the first preset radio station is
broadcast automatically.
Tip
• If no key is pressed during Plug and Play
mode, the system goes to Standby mode
after timeout of 5 times. To go to installation
again, press and hold
Standby mode.
for 3 seconds under
Toexit Plug and Play installation mode
1
press source keys or
control.
»
The system switches to the designated
source mode or standby mode.
Program radio stations
automatically
Note
•
You can program a maximum of 20 preset
radio stations.
1
Press / to select a preset number to
start programing.
2
Press and hold ANGLE/PROG for
2 seconds to activate automatic
programming.
» [AUTO] (auto) is displayed briefly.
»
All available stations are programmed
in the order of waveband reception
strength.
»
The last programed radio station is
broadcast automatically.
Program radio stations
manually
Note
•
You can program a maximum of 20 preset
radio stations.
1
Tune to a radio station.
2
Press ANGLE/PROG to activate
programming.
3
Press / to allocate a number from
1 to 20 to this radio station, then press
ANGLE/PROG to confirm.
»
The preset number and the frequency
of the preset station are displayed.
on the remote
EN 27