Install Remote Control Battery - Philips PD7040/98 User Manual

The charge indicator turns on. It takes about 7.0 hours to fully
»
charge the battery.
When the battery is fully charged, the charge indicator turns off.
»

Install remote control battery

Caution
•
Risk of explosion! Keep batteries away from heat, sunshine or fi re. Never discard
batteries in fi re.
•
Risk of decreased battery life! Never mix different brands or types of batteries.
•
Risk of product damage! When the remote control is not used for long periods,
remove the batteries.
•
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
•
Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
For fi rst-time use:
1
Remove the protective tab to activate the remote control battery.
To replace the remote control battery:
2
Open the battery compartment.
3
Insert 1 CR2025 battery with correct polarity (+/-) as indicated.
4
Close the battery compartment.
EN
16