Replacing The Switch (Xpg); Replacing The Heating Element In The Rear Handle (Xpg); Replacing The Front Handle - Husqvarna 565 Workshop Manual

11.6 Replacing the switch (XPG)

1. To replace the switch the following must be
dismantled (see chapter Replacing the generator):
• Front handle (five to six screws).
• Cables in the front handle (three).
2. Unscrew the screw holding the switch (A).
3. Use a flat screwdriver to dismantle the switch (B).
4. Disconnect the cables. Note the positions of the
cables. See figure 16.
5. Fit the cables on the new switch.
6. Hold the switch with a firm grip against the front
handle while attaching the switch to the front
handle.
Note! Fit the switch carefully and make sure that
the cables are not pinched under the switch.
11.7 Replacing the heating element in
the rear handle (XPG)
1. Unscrew the screw in the rear handle (A). See figure
17.
2. Remove the rear hand grip insert.
3. Remove the cable connections (B and C). See figure
17 and 18.
4. Replace the heating element.
5. Fit the cable connections (B and C). See figure 18.
Note! The cables have to be connected correctly.
Carefully study the illustration.

11.8 Replacing the front handle

1. XPG: Unscrew the cover on the front handle (B, C).
See figure 19.
2. XPG: Disconnect the three cables in the handle
using a pliers. See figure 12 in chapter Replacing
the generator.
3. Remove the front handle (A) (five or six bolts depen-
ding on which handle that is being used). See figure
19.
4. Attach the replacing front handle.
5. XPG: Connect the three cables and fit the cover on
the front handle. See figure 11 and 12 in chapter
Replacing the generator.
C
B
A
C
B
Fig. 16
Fig. 17
Fig. 18
B
C
Fig. 19
Ignition system
A
B
C
A
C
B
2xA
English - 27