Troubleshooting - Breville Easy Mist LAH300 Instruction Book

Troubleshooting

TROUBLE SHOOTING GUIDE
Before carrying out any of the following service checks, unplug the unit from the mains.
PROBLEM
Power indicator blue light
is off or does not work.
The mist has a strange
odour.
Abnormal noise.
The volume of the mist is
too low.
Mist is leaking out from
area surrounding the
mist nozzle.
Mist is leaking from
between the water tank
and water base.
Discolouration on the
heating element.
Lights and beeps on
the unit continue for a
short time after being
disconnected from power.
POSSIBLE CAUSES
•
Humidifier is not plugged into
the power outlet or the plug may
be loose or the power outlet is
not switched on.
•
No, or insufficient water in the
tank.
•
When the humidifier is first
used, there may be some residual
odour that should dissipate.
•
Water in the tank may be dirty or
stagnant.
•
Mineral scale has built up in the
water inlet basin.
•
Essential oil.
•
Vibration in the water basin
because the water level is too low.
•
Mineral scale has built up in
the water inlet basin and/or the
nozzle.
•
Mineral scale has built up in
the water inlet basin and/or the
nozzle.
•
The cover is not sitting correctly.
•
Mineral scale has built up in the
water inlet basin or the nozzle.
•
Water tank is not sitting correctly
on base.
•
This is normal.
•
This is normal.
WHAT TO DO
•
Check the power cord is connected to a
power outlet and turned on, then press the
power on button.
•
Fill the water tank.
•
This is normal for first use. If the smell
does not dissipate, check water quality
as below.
•
Clean the water tank and refill with fresh,
clean water.
•
Clean as per instructions.
•
If using the aroma feature, check that
the essential oil used is not the cause of
the odour and/or too much oil has been
added.
•
Fill the water tank with clean water.
•
Clean as per instructions.
•
Clean as per instructions.
•
Ensure the cover has been fitted correctly.
•
Clean as per instructions.
•
Ensure water tank has been fitted on the
base correctly.
•
The element should be cleaned regularly,
however, discolouration that cannot be
removed is normal with use.
•
Residual energy will fade in a few
seconds.
13