Advertisement
INSTALLATION
NOTE
•
Be careful not to damage the finished surfaces of
the body when installing the bicycle carrier.
•
No more than two bicycles should be carried on the
bicycle attachment.
1.
Slide the upright assembly into the trailer hitch
receiver until the hole in the tube lines up with the
receiver hole. Install the 12 x 40 mm bolt with lock
washer and flat washer through the receiver hole.
Tighten the 12 x 40 mm bolt securely.
TRAILER
HITCH
RECEIVER
UPRIGHT
ASSEMBLY
2.
Lower the bicycle arm bracket onto the upright
assembly as shown.
UPRIGHT
ASSEMBLY
4 8 x 70mm
BOLTS
3.
Assemble the 8 x 70 mm bolts, 8 mm washers,
and nuts as shown. Tighten all four bolts securely.
4.
Install four nut covers.
2 of 4
www.collegehillshonda.com
12 x 40 mm
BOLT
FLAT
LOCK WASHER
WASHER
BICYCLE ARM
BRACKET
4 NUT
COVERS
4 NUTS
4 8 mm WASHERS
5.
Align the tie-down bar and two clamps with the
upright assembly, then secure with the two socket
bolts and two spacers.
UPRIGHT
ASSEMBLY
CLAMPS
TIE-DOWN BAR
6.
Turn the tie-down bar 90° in the direction shown.
This is the stored position.
AII 39487 (0805)
2 SPACERS
6 x 55 mm
SOCKET
BOLTS
TIE-DOWN BAR
© 2008 American Honda Motor Co., Inc. - All Rights Reserved.
Advertisement
