Pioneer AirTies 4920 Installation Manual

It may take up to 24-hours for your new WiFi Mesh
system to optimize to your network!
It is recommended that you follow the coverage guideline of 1,200 square feet per access point device.
1. Disable the existing Gateway/router's "Internet" WiFi function. Instructions on disabling Pioneer's
Gateway WiFi can be found at under the Routers section at www.gopioneer.com/support. (Manage
the ZyXEL Gateway WiFi Settings)
2. Using the enclosed Ethernet cable, connect an AirTies 4920 access point (AP) to a GIGE LAN port on
the back of the Pioneer Gateway or your personal router and power on the AP.
NOTE: The primary AP must be connected to the Gateway/router prior to pairing additional AP's
using WPS.
NOTE: If you have Pioneer DTV service, plug the Ethernet cable into Port 4.
3. To begin the syncing process on the 2
connected directly to the Gateway/router, press and hold the WPS button for 3
seconds and until the 2.4GHz and 5GHz LEDs blink in sync, then do the same for the
nd
2 AP being configured. Within 3 minutes, the 5GHZ LEDs on both Aps should turn
solid GREEN indicating a successful mesh link between the APs.
4. Configure additional mesh Aps by repeating steps 3 and 4.
5. Place 1 AP on each floor OR 1 AP per 1,200 square ft. for optimal coverage ensuring a solid
5GHz LED on all AP device. A solid
the next device.
nd
AP, plug it into a power source. On the AP
GREEN LED indicates each AP has at minimum one strong link to
Press & hold the WPS button for 3
seconds until 2.4 GHz and 5 GHz
LEDs blink in sync.
GREEN