Specifications; Standard Accessories; Optional Accessories (Sold Separately) - Hitachi DH 40MR Handling Instructions Manual

SPECIFICATIONS

Voltage (by areas)*
Power input
Capacity
No load speed
Full-load impact rate
Weight (without cord, side handle)
*Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case (Molded plastic) ............................................... 1
(2) Side Handle ................................................................ 1
(3) Stopper ........................................................................ 1
(4) Hexagon Bar Wrench (for 6 mm screw) ............. 1
(5) Hexagon Bar Wrench (for 5 mm screw) ............. 1
(6) Hexagon Bar Wrench (for 4 mm screw) ............. 1
(7) Hammer Grease A .................................................... 1
Standard accessories are subject to change without
notice.

OPTIONAL ACCESSORIES (sold separately)

1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (SDS max shank)
Outer diameter (mm)
16
19
22
25
28
32
38
40
2. Anchor hole drilling (Rotation + Hammering)
Drill bit (Taper shank)
(3) Cotter
(1) Drill bit (taper shank)
External dia.: 11, 12.3, 12.7,
14.3, 14.5,
17.5 mm
01e_dh40mr_e.p65
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
3. Large dia. hole boring (Rotation + Striking)
(1) Center pin
Overall length (mm)
340, 540
(2) Core bit
320, 520
370, 570
(3) Core bit shank
4. Drilling holes .... For drilling metal and wooden
(2) Taper shank
adapter
(SDS max shank)
6
950 W*
Drill bit: 40 mm
Core bit: 105 mm
240 – 480 min -1
1320 – 2650 min
6.5 kg
Taper shank
Application drill bit
adapter
Morse taper Drill bit (taper shank)
(No. 1) 11, 12.3, 12.7, 14.3, 14.5, 17.5 mm
Adapter for SDS-plus shank bit
(1) Drill bit (2) Adapter for SDS-plus
(SDS-plus shank)
(Guide
(1) Center
(2) Core
plate) pin
bit
Applied to core bits from 38 mm to 105 mm
Applied to core bits 32 mm and 35 mm
NOTE:
Do not use core bits 25 mm or 29 mm.
External dia. 25, 29, 32, 35, 38, 45, 54, 64, 79, 94,
105 mm
(with guide plate, not applicable to cores 25 mm
or 29 mm)
Applied to core bits above 38 mm
Applied to core bits below 35 mm
materials
13 mm drill chuck
(13VLA)
Chuck wrench
1/20/04, 2:13 PM
English
-1
shank bit
(SDS max shank)
(3) Core bit shank
(SDS max
shank)
Chuck adapter
(SDS max shank)
6