Table of Contents
Advertisement
2
Operation
Scanning a Bar Code
1. Press and hold SW2 button on the PC board. LED D5 will light and a laser
scanning line will be emitted.
2. Align the laser line across a bar code.
3. When the kit successfully reads the bar code the kit will beep once and LED
D6 will flash once. The laser will turn off. To turn the LEDs on, release SW2
button, the press and hold the button again.
4. Results are displayed in EZConfig-Scanning Scan Data window.
Scanning Broken or Scratched Bar Codes
The N4300 Evaluation Kit has the ability to scan broken or scratched bar codes.
Move the laser line up and down the bar code. When enabled, the N4300 Eval-
uation Kit can also scan stacked DataBar codes in the same way.
2 - 1
Advertisement
Table of Contents
