NEC 92001 Installation Instructions

124i Power Supply (P/N 92001) Installation
Carefully follow these instructions when replacing the 124i Power Supply.
Unplug each cabinet's power cord before going to Step 1 below. Hazardous
voltages exist inside the cabinet while the power cord is plugged in.
To remove the old 124i power supply:
Step 1
Following the instructions in your system's hardware manual, remove the cabinet cover.
Unscrew the two captive screws that secure the bottom of the cabinet cover.
Lift up the bottom of the cover, then slide the cover up to remove it.
Step 2
Remove the six power supply mounting screws and the screw securing the ground wire.
Instructions
Power Supply Mounting
Screws (6 places)
92001-66
Figure 1 Removing the Mounting Screws
!! Warning !!
Ground Wire
- Over -