6.
Pull the deck support pin outward to release the
deck from the deck lift arm. See Figure 25.
Figure 25
•
Repeat the above steps on the tractor's right side.
•
Move the deck lift lever into the top notch to raise
the deck lift arms up and out of the way.
•
Gently slide the cutting deck toward the front of the
tractor allowing the hooks on the deck to release
themselves from the deck stabilizer rod.
•
Gently slide the cutting deck (from the right side)
out from underneath the tractor.
Changing TheTransmission DriveBelt
NOTE:
Several components
must be removed and
special tools (i.e. air/impact wrench) used in order to
change the tractor's transmission
drive belt. See an
authorized
Toro service dealer to have your drive belt
replaced.
Changing theDeckBelt
WARNING:
Be sure to shut the engine off,
engage the parking brake and remove the
ignition
key to prevent unintended
starting
before removing the belt.
WARNING:
Avoid
the
possibility
of a
pinching injury. Do not place your fingers on
the idler spring or between the belt and a
pulley while removing the belt.
All belts on your tractor are subject to wear and should
be replaced if any signs of wear are present.
IMPORTANT:The V-belts found on your tractor are
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
use factory approved belts.
To change or replace the deck belt on your tractor,
proceed as follows:
•
Remove the cutting deck as instructed earlier in this
section.
•
Remove the belt covers by removing the screws
that fasten them to the deck. Refer to the figure on
the following page.
•
Loosen, but do not remove the deck idler pulleys.
•
Remove the deck belt from around all pulleys,
including the deck idler pulleys.
•
Route the new belt as shown in the figure below
and retighten the deck idler pulleys.
•
Reinstall the belt guards removed earlier and
remount the deck to the tractor.
Changingthe Lower DeckBelt (Model LX460 only)
NOTE:
Several
components
must be removed
in
order to change the lower deck belt (Model LX460). See
an authorized Toro service dealer to have this drive belt
replaced.
28