User Interface/ Control System Test - Whirlpool Cabrio 5800 Series Service Manual

FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY
USER INTERFACE/
CONTROL SYSTEM TEST
Entry Procedure:
Press and release the first button used to activate
Service Diagnostic mode. The following tests will
be available.
NOTE: The Service Diagnostic mode must be
activated before activating the User Interface/
Control System test; see procedure on page 2.
Active Fault Code Display in User
Interface/Control System Test:
If the display (on models with seven segment
display) or WET indicator (on models without
seven segment display) begins flashing while in
User Interface/Control System test, it is displaying
an active fault code. Active fault codes are codes
that are currently failing. Only one active fault
code can be displayed at a time.
Diagnostic Test: Console Buttons
and Indicators
Pressing buttons and rotating the cycle selector
will turn off the corresponding indicator and
sound a beep as shown in figures 1a to 1f,
Console Diagnostics, pages 7–12. If indicators
fail to come on and beep after pressing buttons
and rotating the cycle selector, go to TEST #5,
page 22.
NOTE: A second press of the POWER (POWER/
CANCEL on Maytag models) button while in
Console Buttons and Indicators mode exits the
Service Diagnostic mode and returns the dryer
to standby mode.
Diagnostic Test: Door Switch
(models with seven segment display)
Opening the door should cause a beep and an
alphanumeric number to be displayed. Closing
the door should cause a beep and
displayed.
If opening the door fails to cause a beep and
an alphanumeric number to be displayed, go
to TEST #6, page 22.
(models without seven segment display)
When the door is opened, for electric dryers, the
dryer will beep once and the WET status indicator
will turn on. For gas dryers, the dryer will beep
twice and the DONE or DRY (depending on model)
status indicator will turn on. With the door open,
the TEMP, TEMP LEVEL, or DRY TEMP indicators
(depending on model) will be used to display the
Control Software ID. The TEMP, TEMP LEVEL, or
DRY TEMP indicators will be "On" or "Off"
according to the table below.
Whirlpool Models
Temp Indicators
Kenmore Models
Dry Temp Indicators
If opening the door fails to cause a beep(s),
Control Software ID, or fuel type to be indicated,
go to TEST #6, page 22.
PAGE 5
88
to be
Maytag Models
Temp Level Indicators