Vcr And Cable Box - Sony WEGA KE-37XS910 Operating Instructions Manual

VCR and Cable Box
Your cable company scrambles some channels, such as premmm
channels _which requires you to use a cable box). but does not scramble
all channels.
With this connection, you can use MI the dual picture features,
Use the TV remote control to change channels coming through the cable
box. I You must first program the remote control for your specific cable
pox: see "Programming the Remote Control" on page 52._
Use the TV remote control to change channels coming directly into the
rV's VHF/UHFjack. (The TV's tuner provides a better signal than the
cable box. i
Record channels coming through the cable box and channels coming
directly into the TV
A splitter, which is a small, inexpensive device that you can purchase at
your local electronics store.
Three coaxial cables.
One A/V cable or one S VIDEO cable with audio cables.
Connect the CATV cable to the single (input) jack of the splitter.
Use the supplied antenna cable to connect one of the splitter's two
output jacks to the TV's VHF/UHF jack.
Use a coaxial cable to connect the splitter's other output jack to the
cable box's input jack.
Use a coaxial cable to connect the cable box's output jack to the VCR's
RF input jack.
Use an A/V cable to connect the VCR's A/V output jacks to the TV's
A/V input jacks.
Run the Auto Setup program, as described in "Setting Up the Channel
List" on page 48
Using S VIDEO jacks? See page 29.