Using The Standby Receptions - JVC KD-G637 Instructions Manual

Ÿ
Select one of your favorite programme
types.
or
Select one of the PTY codes (see
page 10).
!
Start searching for your favorite
programme.
If there is a station broadcasting
a programme of the same PTY
code as you have selected, that
station is tuned in.
Storing your favorite programme
types
You can store six favorite programme types.
Preset programme types in the number buttons
(1 to 6):
1
Select a PTY code (see above).
2
Select the preset number (1 – 6) you want to
store into.
Ex.: When "ROCK M" is selected
3
Repeat steps 1 and 2 to store other PTY
codes into other preset numbers.
4
Finish the procedure.

Using the standby receptions

TA Standby Reception
TA Standby Reception allows the unit to switch
temporarily to Traffic Announcement (TA) from any
source other than AM.
The volume changes to the preset TA volume level if the
current level is lower than the preset level (see page 16).
To activate TA Standby Reception
The TP (Traffic Programme) indicator
either lights up or flashes.
• If the TP indicator lights up, TA Standby Reception is
activated.
• If the TP indicator flashes, TA Standby Reception is
not yet activated. (This occurs when you are listening
to an FM station without the RDS signals required for
TA Standby Reception.)
To activate TA Standby Reception, tune in to another
station providing these signals. The TP indicator will
stop flashing and remain lit.
To deactivate the TA Standby Reception
The TP indicator goes off.
Continued on the next page
9