The B.e.s.t. Picture System - JVC HR-S6975EK Instructions Manual

34
advanced features
about b.e.s.t.
Works in SP and LP
modes
Works before Timer
Recording
B.E.S.T. data is lost
when tape is ejected
Pressing the T button on
VCR does not start Instant
Timer Recording while
B.E.S.T. is turned ON
Recording and Playback Using B.E.S.T.
recording Press and hold T and press . on the Remote Control (or press T on the VCR). The
VCR spends about 7 seconds assessing the condition of the tape and then begins recording.
During B.E.S.T.
playback Press .. The VCR adjusts the playback picture quality
based on the condition of the tape in use. B.E.S.T. is active during
Auto Tracking.
Avoiding B.E.S.T. Time Delay
Since B.E.S.T. introduces a 7 second delay before recording starts, you may wish to compensate by
first pressing | and T together (this puts the VCR into
the VCR performs the B.E.S.T. tape assessment) and then pressing . when you wish to start
recording.
The B.E.S.T.
Picture System
The Biconditional Equalised Signal Tracking (B.E.S.T.) System checks the
condition of the tape in use and compensates during recording and playback
to give the best picture quality possible. The default setting is ON.
Turning B.E.S.T. ON or OFF
get to the mode set screen Press MENU button. Move the highlight bar to
using the PR
MODE SET
and press OK button (or
select b.e.s.t. mode Move the highlight bar to
using the PR
B.E.S.T.
press OK button (or
.
OFF
return to normal screen Press MENU
button.
S-VHS VCR
a
pause of 7 seconds
appears on the VCR's display panel.
bESt
and PR buttons
).
and PR buttons and
) to set or
B.E.S.T. ON
S-VHS
a
B.E.S.T. complete
RECORD PAUSE
MODE SET
S-VHS ET OFF
F
B.E.S.T. ON
PICTURE CONTROL AUTO
AUTO TIMER OFF
O.S.D. ON
AUTO SP a LP TIMER OFF
POWER SAVE OFF
NEXT PAGE
[1] a k
[MENU]: EXIT
VCR
S-VHS VCR
mode during which time