Preparation; Connecting The Ac Power Cord; Connecting To Outdoor Antenna - Sanyo PLV-45WR1Z Owner's Manual

Preparation

Connecting the AC Power Cord

This LCD projection TV uses nominal input voltages of 100-120 V
or 200-240 V AC. This LCD projection TV automatically selects the
correct input voltage. It is designed to work with single-phase
power systems having a grounded neutral conductor. To reduce
risk of electrical shock, do not plug into any other type of power
system.
Consult your authorized dealer or service station if you are not sure
of the type of power being supplied.
Connect the LCD Projection TV with all peripheral equipment
before turning the LCD Projection TV on. (See p14, 15 for
connection.)
AC Power Cord
CAUTION
For safety, unplug AC power cord when the LCD Projection TV
is not in use.
When this LCD Projection TV is connected to an outlet with AC
power cord, it is in Stand-by mode and consumes a little electric
power.
THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILY ACCESSIBLE.

Connecting to Outdoor Antenna

Antenna
Connect an antenna cable to the VHF/UHF jack on the rear of the
LCD Projection TV.
To the AC Outlet.
(200 - 240 V AC)
Connect AC Power Cord (supplied) to the LCD
Projection TV. The AC outlet must be near this
equipment and must be easily accessible.
Outdoor
Antenna
Antenna Cable
VHF/UHF jack
13