Installing Junction Box - Motorola MTM800 FuG Installation Manual

Number
1
2
3
4
5
6
7
8
9
10
11
12
13
Note: The junction box PCB is not repairable. Order a new junction box as necessary.

Installing Junction Box

The junction box can be installed horizontally and vertically. The junction box has no connector sealing and is
designed for use in dust and water protected location only. See the following figure.
Procedure:
1 Secure the data junction box with the four screws supplied with kit.
2 Connect the connection cable (length = 6 m), (length = 4 m) or (length = 2 m) from the junction box to the
accessory connector on the rear side of the transceiver and fasten it with the plug-screws.
The cable used for installation purposes only must be ordered separately. Ingress Protection (IP) Code: IP30
3 All other devices should be adapted as shown in the preceding figure.
Connecting Accessories to the Junction Box
Procedure:
1 Connect all accessories to the junction box. If required see "Re-crimp Procedure" to be able to connect your
accessory.
2 Connect the mobile-terminal-to-Junction box cable to the junction box.
3 Connect the programming cable to the junction box (if required).
Description
to MTM800 Enhanced accessory connector
Speaker
Visor microphone GMMN4065_
Connecting cable PMKN4101/2/3_
External PTT
To Ignition Switch
External Alarm
Emergency Switch
Fist Microphone GMMN4063_
Junction Box GMLN5089_
Accessory Connector Kit GMBN1021_
Standard RS232 cable
Laptop
Radio Installation | 69
68015000584-J | | Send Feedback