Zicom Z.HA.HA.SIGN.ATOUCH.REPETER User Manual

Signal Repeater
Z.HA.HA.SIGN.ATOUCH.REPETER
User Manual
Introduction
The repeater is a wireless signal relay transmission device. With
MCU technology, it can decode the signal in the air and
strengthen the transmitting power to extend the transmission
distance range. Failure to receive signal to panel from wireless
accessories is frequently happened due to the long distance range
when the remote controlling or wireless alarm systems are applied
to large scale of commercial tall buildings, villa, and industrial
areas. This wireless signal repeater could solve this problem and
further distance range signal transmitting could be achieved.
Product Overview
Note: Please pull out the antenna for optimal performance.
LED Indication
Green LED on: working status
Blue LED flashes once: signal transmitting
Green and blue LEDs flash alternatively: in connect status
Adding and Deleting Accessories
When adding or deleting accessories, you should make this
repeater in learning or deleting accessories status. Firstly, turn
the switch from OFF to ON (If the repeater is in ON status,
switch it to OFF first and then switch it to ON), the repeater will
enter learning or deleting accessories status for one minute
while the green and blue light flash in turn.
Extend Transmission Distance between Accessories And
Control Panel
When the repeater is in connect status, press its connect
button, then trigger a wireless sensors (For example, press any
button on the remote control or separate the transmitter and
magnet of the door/window contact). The blue LED lights up for
2 seconds and goes off, then the green and blue LEDs flash
alternatively. If the repeater is still in connect status, you can
repeat the above operation to add more accessories.
Note: If the repeater exits the connect status, switch off and then switch on the
repeater to re-enter the connect status. Then repeat the above operation to add
more accessories.
Workflow:
Extend Transmission Distance between Control Panel and
Siren
Press the connect button under connect status. Press the SOS
or arm button on the control panel, the repeater succeeds in
connecting with the control panel after the blue LED lights up
for 2 seconds and goes off. Then the green and blue LEDs flash
alternatively.
Workflow:
Deleting Accessories
Press and hold the connect button for 5 seconds under connect
status, the repeater disconnects from all accessories after the
blue LED lights up for 2 seconds and goes off. Then the green
LED keeps on.

Specifications

Power Supply: AC 110V-240V, 50/60Hz
Wireless Transmitting
Wireless Receiving Range:
Radio Frequency: 315MHz or 433MHz (±75KHz)
Static Current: <15.5mA
Transmitting Current: <1.1A
Maximum Accessories
Back-up Battery: 3.7V 600mAh Lithium Battery, 2.22Wh
Housing Material: ABS plastic
Operation Condition:
Temperature: 0°C ~ +55°C
Relative Humidity: <80% (non-condensing)
Dimension^ x W x H): 140 x 86 x 87mm
Zicom Electronic Security Systems Ltd.|
th
Address: 501, 5 Floor, Silver Metropolis, Goregoan (E), Mumbai–400 063, India.
Website: www.zicom.com | Toll Free : 1-800-270-4567
Range: <300m
<90m
Supportable: 40 PCS