Removing The Sensor Board; Prerequisites; Procedure - Dell Inspiron 15 5000 Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.

Prerequisites

1. Remove the base cover.
2. Remove the battery.
3. Remove the display assembly.
4. Follow the procedure from step 1 to step 2 in

Procedure

CAUTION: Place the display-panel assembly on a soft and clean surface to avoid scratching the display.
1. Place the display-panel assembly face down on a flat surface.
2. Remove the screw that secures the sensor board to the display panel.
3. Peel off the tape that secures the sensor-board cable to the sensor board.
4. Open the latch to disconnect the sensor-board cable from the sensor board.
5. Lift the sensor board off the display-panel assembly.
Figure 38. Removing the sensor board
1. tape
3. sensor-board cable

Removing the sensor board

computer. After working inside your computer, follow the instructions in
"Removing the display panel".
2. latch
4. screw
Removing the sensor board
45
After
69