Using The Tool - Black & Decker 492848-00 Instruction Manual

492848-00,BDN200 NAILER

USING THE TOOL

Complete all steps of PREPARING THE TOOL before using the tool.
This tool is shipped from the factory with a "single sequential actuation" trigger. To
fire, grip the tool firmly to maintain control, position nose of tool onto work
surface, push the tool firmly against work surface to depress safety (S) Fig. 28,
and squeeze trigger to fire a nail. Allow tool to recoil away from work surface as nail
is driven. This "single sequential actuation" method provides the most accurate
fastener placement.
Disconnect tool from air supply before performing
maintenance, clearing a jammed fastener, leaving work area, moving tool to
another location, or handing the tool to another person.
Clean and inspect tool daily. Carefully check for proper operation of trigger and
safety mechanism. Do Not use the tool unless both the trigger and the safety
mechanism are functional, or if the tool is leaking air or needs any other repair.
2/2/06 1:35 PM Page 8
A
A
Fig. 26
OPERATING INSTRUCTIONS
Fig. 28
8
Fig. 27
S