Specifications; Standard Accessories - Hitachi H 60MC Handling Instructions Manual

DEMOLITION HAMMER SAFETY WARNINGS
1. Wear ear protectors
Exposure to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Do not touch the bit during or immediately after
operation. The bit becomes very hot during operation
and could cause serious burns.

SPECIFICATIONS

Voltage (by areas)*
Power Input*
Full-load Impact Rate
Weight (without cord, side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case ..........................................................................1
l type: bar type handle ........................1
(2) Side Handle
ll type: D type handle ..........................1
Either type l or type ll Side handle is attached.
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
○ Demolishing
(1) Bull Point
Overall Length: 280, 400 mm
○ Asphalt Cutting
(1) Cutter
○ Surface Roughing
+
(1) Bushing Tool
○ Tamping
+
(1) Rammer
(2) Shank
(2) Shank
4. Before starting to break, chip or drill into a wall, fl oor or
ceiling, thoroughly confi rm that such items as electric
cables or conduits are not buried inside.
5. Wear a mask when turning your head upward.
6. Properly set the bit holder.
7. At the start of work, confi rm screw tightening.
8. When working at a highly elevated location, pay
attention to articles and persons below.
9. Wear protective shoes to protect your feet.
(110 V, 120 V, 127 V, 220 V, 230 V, 240 V)
1250 W
1600/min
10.2 kg
○ Groove digging and edging
(1) Cold chisel
Overall Length: 280, 400 mm
○ Scooping Work
○ Hammer Grease A
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without
notice.
APPLICATIONS
Demolishing concrete, chipping off concrete, grooving,
bar cutting, and driving piles.
Application examples:
Installation of piping
installation, machinery installation, water supply and
drainage work, interior jobs, harbor facilities and other civil
engineering work.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
English
(1) Scoop
and wiring, sanitary facility
5