Safety Features; Cleaning And Storage - Honeywell HZ-420 Series Instructions Manual

OPERATION
(CONTINUED)
To set the heater, the digital control is equipped with two (2) modes:
Constant Heat - there are two (2) heat settings
1. For Constant Low, press (
2. For Constant High, press (
NOTE: The Low (
) setting does not require as much electricity to operate. It is more energy efficient
and may be a better option if you are concerned about saving energy.
EnergySmart Mode -
®
A smart thermostat that helps you save energy. Press SET to choose four (4) comfort settings of 65° (18°),
70° (21°), 75° (24°), 80° (27°). This is your desired room temperature. The EnergySmart
will automatically select the appropriate power level to best accommodate your Desired Temperature.
As the air temperature (Current Temp) in the room approaches the Desired Temperature, the heater will
automatically lower the power consumption to provide consistent warmth without wasting energy.
The Current Temp Indicator will display the current room temperature.
NOTE: In the EnergySmart
heater has automatically selected to efficiently meet your Desired Temperature.
• To override the EnergySmart
Heat mode. The Energy Usage guide will indicate STAND BY when the heater has reached the
Desired Room Temperature. At this point, the heater is most efficient and is drawing only a few
watts of energy while in STAND BY mode.
• To set the Timer, press the (
for that chosen period in the selected mode and automatically shut off after the desired time has
passed.

SAFETY FEATURES

The 360º Ceramic Surround Heater is equipped with several devices and features for added protection:
• 360° SafetyTIP™ is an all-around tip-over switch that disables the heater if it is accidentally tipped
in any direction.
• A high temperature safety control prevents overheating.
• This heater is also equipped with a thermal cut-off fuse that will permanently shut down the heater
should it operate at a higher than normal temperature.
• This heater was created using a high quality safety plastic.

CLEANING AND STORAGE

We recommend that the 360º Ceramic Surround Heater be cleaned at least once a month and before
off-season storage.
• Turn the heater OFF (
• Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER, WAXES,
POLISHES OR ANY CHEMICAL SOLUTION.
• Before storing, clean the 360º Ceramic Surround Heater using the above-mentioned steps. Wrap the
cord around the unit. Place in its original box and store it in a cool, dry place.
• This heater does not disassemble.
); this setting uses 900 watts of power
); this setting uses 1500 watts of power
mode, the Energy Usage Indicator will display what power consumption the
®
function, turn the heater OFF (
®
) button to select 1, 2, 4, or 8 hour setting. The heater will run
) or ( ) and unplug it. Allow it to cool.
thermostat
®
) or press SET to choose a Constant
5