Table of Contents
Advertisement
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing the
PA-2CE1. This chapter contains the following sections:
•
•
•
•
•
Required Tools and Equipment
You need the following tools and parts to install a port adapter. If you need additional equipment, contact
a service representative for ordering information.
•
•
•
•
•
•
•
OL-3519-01
Required Tools and Equipment, page 2-1
Software and Hardware Requirements, page 2-2
Checking Hardware and Software Compatibility, page 2-2
Safety Guidelines, page 2-3
FCC Class A Compliance, page 2-7
PA-2CE1/PRI-75(=) or PA-2CE1/PRI-120(=).
VIP2 (for installation in Cisco 7000 series or Cisco 7500 series chassis only). For information about
the specific VIP2 models that support the PA-2CE1, see the "Software and Hardware Requirements"
section on page 2-2.
E1 interface cables. (See the "Cables, Connectors, and Pinouts" section on page 1-3.
Number 1 Phillips and a 3/16-inch flat-blade screwdriver (for VIP2 installation only).
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares.
Antistatic mat.
Antistatic container.
C H A P T E R
PA-2CE1 Channelized E1 Port Adapter Installation and Configuration
2
2-1
Advertisement
Table of Contents
