Download
Share
Print this page
Kenmore Smart Water Heater Module Quick Start Install Manual
  1. Manuals
  2. Brands
  3. Kenmore Manuals
  4. Water Heater
  5. Sensor smart electric dryer
  6. Quick start install manual
Kenmore Smart Water Heater Module Quick Start Install Manual

Kenmore Smart Water Heater Module Quick Start Install Manual

Hide thumbs Also See for Smart Water Heater Module:

Advertisement

Quick Links

Download this manual See also: Use and Care Manual, Installation Instructions & Owner's Manual
®
®
Quick Start & Install Guide
Smart Water Heater Module

Advertisement

loading

Related Manuals for Kenmore Smart Water Heater Module

Summary of Contents for Kenmore Smart Water Heater Module

  • Page 1 ® ® Quick Start & Install Guide Smart Water Heater Module...
  • Page 3 Kenmore Smart Water Heater Module ® With Leak Detection Module (included), A Kenmore Connected Ready Water Heater, ® A wireless router with working internet connection and a smartphone. It’s easy!
  • Page 4 Preparation Before you start the installation, here is what you will need: • Kenmore ® Smart Water Heater Module with Leak Detector • Home router with internet access • iOS or Android smartphone • #2 Phillips screwdriver, and • One of these Kenmore ®...
  • Page 5 Preparation (Cont’d) Note the locations of the various key features of ® the Kenmore Smart Water Heater Module: Control Button: Clearance Holes for • Connect Smart Mounting Screws (2) • Leak Detector Reset Beeper Leak Sensor Plug Cover Smart Connected...
  • Page 6 Install the Smart Water Heater Module WARNING! Working on an energized circuit can result in severe injury or death from electrical shock. Turn power off before performing this installation. Check wires with a non-contact circuit tester to make sure power is off . If you have a smart electric water heater, follow these steps: Step 1: Turn power off...
  • Page 7 Install the Smart Water Heater Module (Cont’d) If you have a heat pump water heater, follow these steps: Step 1: Turn power off at source (circuit breaker). Step 2: Remove plug access cover. Discard screws. Longer screws are provided. Step 3: Plug in module. Figure 3: Control panel shown;...
  • Page 8 Install the Leak Sensor Step 1: Remove the leak sensor plug cover. See Figure 1. Step 2: Plug the sensor’s connector into the module. See Figure 4. Step 3: Peel the backing off of the sensor’s adhesive tape (located on the back of the sensor). IMPORTANT: The sensor must be mounted to a surface that is clean and dry.
  • Page 9 Figure 4: Module Leak Sensor Installation Install sensor plug. • IMPORTANT: Read the instructions before attaching the sensor. • Figure shows installation on a smart electric water heater. Use the same procedure for a heat pump water heater. Wire Clip Sensor Suitable Drain Pan...

  • Page 10: Turn On Power

    Turn on Power If you are installing the Kenmore ® Smart Water Heater Module on one of these models, turn your water heater on according to its use and care guide, then go to Section 5: • 153.582400 • 153.582500 •...
  • Page 11 Enable the Water Heater Follow these steps if you have a smart electric water heater with a control panel (shown below). If you have a heat pump water heater, skip these steps and go to the next page. Step 1: Watch the water heater’s display screen for the Remote Access icon to appear (Figure 5).
  • Page 12 Enable the Water Heater (Cont’d) Follow these steps if you have a heat pump water heater. Otherwise, go to Section 6. Step 1: After turning power on, wait for the diagnostics to run. It will Figure Figure 6: Heat take up to eight minutes for the Pump User Interface and water heater to complete its Controller...
  • Page 13 Enable the Water Heater (Cont’d) Step 2 continued... The screen will display the following: (1 second) (1 second) (1 second) (3 seconds; indicates temperature set point) When this process is complete, remote access is enabled. The water heater can be controlled both locally and remotely.
  • Page 14 ® Smart app makes it easy to set up, program and control your Kenmore ® Smart Water Heater Module and other Kenmore ® Smart products. Apple, the Apple logo and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries.

  • Page 15: Customer Care

    Customer Care If you need help connecting your ® Kenmore Smart Water Heater Module, call 1-844-553-6667 or visit www.kenmore.com/smart...

  • Page 16: Kenmore Limited Warranty

    Kenmore Limited Warranty FOR ONE YEAR from the date of sale this product is warranted against defects in material or workmanship when it is correctly connected, operated and maintained according to all supplied instructions. WITH PROOF OF SALE, return a defective product to the retailer from which it was purchased for free replacement.

  • Page 17: Regulatory Notices

    Regulatory Notices FCC (UNITED STATES): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, (2) This device must accept any interference received including interference that may cause undesired operation.
  • Page 18 Notes...
  • Page 19 Notes...
  • Page 20 ® www.kenmore.com | www.kenmore.com/smart Copyright © Sears Brands Management Corporation All Rights Reserved. 100262942...