Installation Of The Board; Plug-In Board Installation - Sony BKSI-2440 Series Installation Manual

1-2. Installation of the Board

This section describes the installation procedures for the
front plug-in board and rear connector panel in a System
Interface Unit SIU-80A/80.
For more details of each procedure, refer to the applicable
sections and Installation Manual supplied with SIU-80A or
SIU-80.

1-2-1. Plug-in Board Installation

Flow for installation
Start
Slot selection
Switch setting on board
Plug-in board installation (BKSI-2440)
Compact flash card installation
Model label attachment
End
General information for installation
. The plug-in board (BKSI-2440) is inserted into any slot
No.1 to No.8 in the front of SIU-80A/80.
For the number of maximum boards to be installed in
SIU-80A/80, refer to the Installation Manual supplied
with SIU-80A or SIU-80.
. Install the Plug-in board (BKSI-2440) before inserting
the Compact flash card supplied with the BKS-2440 in
it.
. The model label supplied with the board is attached to
the shield plate to prevent the board inserting into the
incorrect slot when the board replacement and others.
BKSI-2440
Procedures
1. Turn the SIU-80A/80 power off and remove the front
panel and shield plate.
(Refer to the Installation Manual supplied with SIU-
80A or SIU-80.)
2. Set the switches on the board. (Refer to "1-4-1. Setting
and Function of Switches/LEDs on Board".)
3. Insert the board into a slot, and then turn the board
levers in the direction of the arrow 1 and connect the
board securely to the connector of the SIU-80A/80
units mother board.
4. Insert the Compact flash card into the Plug-in board.
Compact flash card
Plug-in board
2
1
Board lever Board lever
1 1
2
5. Install the shield plate.
Then, attach the model label supplied with the board
on the right side of the shield plate.
This label position should be aligned with the slot
installing the board.
6. Install the front panel.
PSW 3 x 6
Front panel
n
When removing the board, pull the board out from the
slot turning the board levers in the direction of the
arrow 2.
SIU-80A/80
1
Install
2
2
Remove
SIU-80A/80
Model label
Shield plate
1-3 (E)