Advertisement
Mounting an Addressable Multi-Module in the ROME Series
MULTIMOD-BRKT Mounting Bracket Installation
An addressable Multi-Module communicates with the FACP via the SLC loop. A Multi-Module can be installed inside
the ROME Series enclosure using the MULTIMOD-BRKT module mounting bracket. Install the MULTIMOD-BRKT as
described below.
1.
Place the MULTIMOD-BRKT mounting bracket flat against the inside back wall of the ROME Series, while
positioning two oblong holes over the mounting studs as shown in the following illustration.
2.
Make a mark on the ROME Series back wall using the two holes that will be used to secure the MULTIMOD-BRKT
as a guide.
3.
Remove the MULTIMOD-BRKT from the ROME Series and drill two 3/32" (dia. 0.093") holes in the locations
marked in step 2. Note that these holes will be used to secure the MULTIMOD-BRKT using the two supplied self-
tapping screws.
4.
Place the MULTIMOD-BRKT mounting bracket oblong holes in position over the mounting studs and install the two
supplied nuts, but do not tighten at this time.
5.
Install the two supplied self-tapping screws in the locations indicated and secure the MULTIMOD-BRKT to the
ROME Series using the holes drilled in step 3.
6.
Tighten the two nuts installed in step 4.
ROME Series Installation Document — P/N 53530:B 9/14/2009
self-tapping screw
self-tapping screw
ROME Series
mounting stud
(with nut)
drill 3/32" (dia. 0.093")
hole in ROME Series for
self-tapping screw
MULTIMOD-BRKT
Mounting Bracket
drill 3/32" (dia. 0.093")
hole in ROME Series for
self-tapping screw
mounting stud
(with nut)
oblong mounting hole
oblong mounting hole
5
Advertisement
