Table of Contents
Advertisement
Configuring the Interfaces
Configuring the Interfaces
After you verify that the new PA-4B-U is installed correctly (the enabled LED goes on), use the
configure command to configure the new interfaces. Have the following information available:
•
•
•
Table 4-1
Keywords by Area
Australia
Europe
Japan
North America
New Zealand
Note
Cisco 7200 series routers do not support a combination of installed ISDN PRI and ISDN BRI interfaces.
The ISDN switch type (PRI or BRI) that you identify during an ISDN configuration is for all ISDN
interface ports installed in the router.
PA-4B-U Basic Rate Interface Port Adapter Installation and Configuration
4-2
Protocols and encapsulations you plan to use on the new interfaces
Protocol specific information, such as IP addresses if you will configure the interfaces for IP routing
The ISDN switch type
(Table 4-1
ISDN Service Provider Switch Types
Switch Type
basic-ts013
Australian TS013 switches
basic-1tr6
German 1TR6 ISDN switches
basic-nwnet3
Norwegian NET3 ISDN switches (phase 1)
basic-net3
NET3 ISDN switches (UK, Denmark, and other
nations); covers the Euro-ISDN E-DSSI signaling
basic-net5
system)
primary-net5
NET5 switches (UK and Europe)
vn2
European ISDN PRI switches (UK and Europe)
vn3
French VN2 ISDN switches
French VN3 ISDN switches
ntt
Japanese NTT ISDN switches
primary-ntt
Japanese ISDN PRI switches
basic-5ess
AT&T basic rate switches
basic-dms100
NT DMS-100 basic rate switches
basic-ni1
National (North American) ISDN-1 switches
primary-4ess
AT&T 4ESS switch type for the U.S. (ISDN PRI only)
primary-5ess
AT&T 5ESS switch type for the U.S. (ISDN PRI only)
primary-dms100
NT DMS-100 switch type for the U.S. (ISDN PRI
only)
basic-nznet3
New Zealand NET3 switches
Chapter 4
lists ISDN service provider switch types)
Configuring the PA-4B-U Interfaces
OL-3521-02
Advertisement
Table of Contents
