Figure 8; Pa-2Jt2 In Port Adapter Slot - Cisco PA-2JT2 Installation And Configuration Manual

Port adapters and VIP2 carriers have handles attached, but these handles are occasionally not shown in
Note
this publication to allow a full view of detail on each port adapter faceplate.
shows a VIP2-50 with two JT2 port adapters installed in port adapter slots 0 and 1.

Figure 8

SRAM
daughter
card
PA-2JT2 in
port adapter
If a blank port adapter is installed on the VIP2 in which you want to install a new port adapter, you must
Note
first remove the VIP2 from the chassis, then remove the blank port adapter.
To prevent system problems, do not remove port adapters from the VIP2 motherboard or attempt to
Caution
install other port adapters on the VIP2 motherboard while the system is operating. To install or replace
port adapters, first remove the VIP2 from its interface processor slot.
When only one port adapter is installed on a VIP2, a blank port adapter must fill the empty slot to allow
the VIP2 and router chassis to conform to electromagnetic interference (EMI) emissions requirements,
and so that air flows through the chassis properly. If you plan to install a new port adapter, you must first
remove the blank port adapter.
OL-3587-01
VIP2-50 with Two JT2 Port Adapters (Horizontal Orientation Shown)
Bus connector
slot 0
Port adapter handles not shown
Boot ROM CPU
JT2
PA-2JT2 6.3-MHz Serial Port Adapter Installation and Configuration
VIP2 and the JT2 Port Adapter
SDRAM DIMM
PA-2JT2 in
port adapter
slot 1
JT2
13