Advertisement
Quick Links
GE Appliances
Training Bulletin
December 2012
INTRODUCTION
In compliance with Department of Energy requirements,
GE has introduced 2 cordless battery-powered ignition
30-in. free-standing gas ranges:
GE model JGBS14PCD
Hotpoint model RGB518PCD
RANGE FEATURES
•
Standing gas pilots have been replaced with
electronic spark ignitors.
•
Surface burners use spark ignition similar to previous
models.
•
Ovens use a pilot burner and thermocouple
confi guration.
•
Oven thermostat controls both oven burner and oven
pilot operation.
•
Gas is used only when surface burners or oven are
turned on.
•
AC voltage not required or used for range operation.
•
The ignitors are powered by a 9-volt battery.
•
The battery is conveniently located in a
compartment on the front of the range behind the
broiler door.
•
GE models include a low battery indicator light
located on the left side of the control panel.
GE Appliances
General Electric Company
Louisville, Kentucky 40225
GE Cordless Gas Range
Models: JGBS14PCD RGB518PCD
– 1 –
TB05-12
GE model
JGBS14PCD
Hotpoint model
RGB518PCD
Advertisement
Related Manuals for GE JGBS14PCD
Summary of Contents for GE JGBS14PCD
- Page 1 The battery is conveniently located in a compartment on the front of the range behind the broiler door. • GE models include a low battery indicator light located on the left side of the control panel. GE Appliances General Electric Company Louisville, Kentucky 40225 –...
- Page 2 MINI-MANUAL AND LP CONVERSION KIT: 3. Lift the back of the oven bottom then remove the bottom from the oven cavity. The Mini-manual and the LP conversion kit are attached to the back of the range near the gas inlet pipe with a 4.
- Page 3 1 second. 1. Remove the battery tray. (See To replace the • When the green battery indicator light (GE models) battery, follow steps 1 through 3.) fails to glow during sparking. 2. Remove the 2 Phillips-head screws from the front of •...
- Page 4 SPARK MODULE 5. Remove the 2 Phillips-head screws from the front of the control panel. The spark module, similar in appearance to previous models, is now powered by the 9-volt battery. The module is attached to the inside of the module cover with two 1/4-in.