Clutch Pedal - Suzuki CELERIO Series Owner's Manual

Gear Oil Level Check
EXAMPLE
(1) Oil filler and level plug
To check the gear oil level, use the follow-
ing procedure:
1) Park the vehicle on a level surface with
the parking brake applied. Then, stop
the engine.
2) Remove the oil filler plug (1).
3) Check the inside of the hole with your
finger. If the oil level comes up to the
bottom of the plug hole, the oil level is
correct. If so, reinstall the plug.
4) If the oil level is low, add gear oil
through the oil filler plug hole (1) until
the oil level reaches the bottom of the
filler hole, then reinstall the plug.
Tightening torque (1):
21 Nm (2.1 kg-m, 15.5 lb-ft)
CAUTION
After driving the vehicle, the tran-
saxle oil temperature may be high
enough to burn your skin. Wait until
the oil filler plug is cool enough to
touch with your bare hands before
inspecting transaxle oil.
68KH073
NOTICE
When tightening the plug, apply the
following sealing compound
equivalent to the plug threads to pre-
vent oil leakage.
Manual transaxle/Auto Gear Shift
sealant:
SUZUKI Bond No. "1217G"
Gear Oil Change
Since special procedures, materials and
tools are required, it is recommended that
you trust this job to your authorized
SUZUKI dealer.
INSPECTION AND MAINTENANCE

Clutch Pedal

Cable control clutch (if equipped)
or
Clutch pedal play "d":
10 - 15 mm (0.4 - 0.6 in.)
Measure the clutch pedal play by moving
the clutch pedal with your hand and mea-
suring the distance it moves until you feel
slight resistance. The play in the clutch
pedal should be between the specified val-
ues. If the play is more or less than the
above, or clutch dragging is felt with the
pedal fully depressed, have the clutch
inspected by your SUZUKI dealer.
EXAMPLE
54G274
7-28
84MM6-01E