Siemens SCALANCE X-200 Series Compact Operating Instructions page 87

● Keep to the installation guidelines
● You can always find the latest documentation on the Internet!
● Working on the product
Machinery directive
The product remains a component in compliance with Article 4 (2) of the EC Machinery
Directive 89/392/EEC.
According to the machinery directive, we are obliged to point out that the product described
is intended solely for installation in a machine.
Before the final product can be put into operation, it must be tested to ensure that it conforms
with the directive 89/392/EEC.
Note for the manufacturers of machines
This product is not a machine in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 89/392/EEC for this
product.
Explosion protection directive (ATEX)
The SIMATIC NET product meets the requirements of the EC directive:
94/9/EC "Equipment and Protective Devices for Use in Potentially Explosive Atmospheres"
Note
When using (installing) SIMATIC NET products in hazardous area zone 2, make absolutely
sure that the associated conditions are adhered to.
You will find these conditions on the SIMATIC NET Manual Collection.
SCALANCE X-200
Compact Operating Instructions, 12/2010, A5E00813159-11
The product meets the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the product.
The current descriptions of the currently available products can always be found on the
Internet under the specified entry IDs/Internet pages:
– SIMATIC NET Industrial Twisted Pair and Fiber Optic Networks Manual
8763736
– EMC Installation Guideline, Planning Guide
28518276
To protect the product from electrostatic discharge, personnel must first discharge any
electrostatic charge from their body before touching the product.
Note
The product was tested with a device that also complies with the standards listed above.
If the product is operated with a device that does not meet these standards, there is no
guarantee that the corresponding values will be adhered to.
Certifications and approvals
6.1 Notes on the CE Mark
87