Advertisement
Installing Power Components
Installing DC Terminal Block Covers
Figure 22: DC Terminal Block Cover, on page 33
Figure 22: DC Terminal Block Cover
Install the terminal block cover after the input wiring is installed, but before power has been energized.
Caution
Required Tools and Equipment
You need the following tools to perform this task:
• 6-in. long Number 1 Phillips screwdriver
• Terminal block covers
• Torque screwdriver with Number 1 Phillips head and a torque rating of 5 to 7 in.-lb
Steps
To install the DC terminal block covers, go to the rear (MSC) side of the chassis and perform the following
steps:
shows the DC terminal block cover.
Cisco CRS Routers 16-Slot Line Card Chassis Enhanced Router Installation Guide
Installing AC or DC Power Shelf Wiring
33
Advertisement
