Operator Maintenance - Canon BLM 550+ Service Support Manual

Canon
G. Operator Maintenance
Periodic operator maintenance is required to ensure a specific level of machine
performance. The following tasks should be conducted by the customer
operator(s).
Table 19 – BLM550+ Operator Maintenance
Weekly
Either of the following:
•
Monthly
•
When a new stich wire is installed
•
When the message "OPERATOR
MAINTENANCE"
on the screen (approximately
every 20,000 stitches).
10
The "OPERATOR MAINTENANCE" message appears after 20,000 stitches and is accompanied by a repeated beeping from
the machine. After another 2,000 stitches the machine locks. Operator Maintenance (including the lubrication and cleaning) will
reset the counter and resume machine operation.
BLM550+ Booklet Maker Service Support Guide
Revision 1
Interval
10
is displayed
BLM550+ Booklet Maker Service Support Guide
Task
Clean the stitcher head (surface only)
(Tools to perform this maintenance are
included with the BLM550+).
•
Lubricate the stitch head (Note: this
should be performed even when the
machine is not in use)
•
Lubricate the stitch head
•
Clean the square spine forming clamp to
prevent stripes appearing on the side of
the booklet spine
•
Clean the square spine form roller to
prevent lines appearing on the booklet
spine
•
Clean trimming removals fingers
•
Clean excess grease from the stitch
head
March 2015
Page 16