Sony RM-AV3000 Operating Instructions (primary manual) Operating Instructions Manual page 66

Setting the Timer (continued)
4
When the program number of
which contents you want to
change appears on the left Label
key, press that Label key.
With a beep sound, the contents of
selected program is copied to the
program number on the Mode
Display key (in this case, PROG4).
The day of the week and the time for
the copied timer program are
displayed on the Clock Display key.
"ON/OFF," "TEST," "SETUP," and
"COPY" flash on the Label keys.
5
Press the SETUP key.
"DAY," "TIME," and "MACRO" flash.
66
6
Press the key of which contents
you want to change.
DAY: See Step 5 on page 62.
TIME: See Step 6 on page 63.
MACRO: The display turns as below.
7
Press the OK key.
With a beep sound, the Timer Macro
setting is cleared, and the Commander
enters the Timer Macro setting mode
(Step 7 on page 63).
If you press the NG key
The display returns to Step 5.
Note
You cannot change the Timer Macro
setting partially. If you want to change
the program without clearing the
frequently used procedure, use the
System Control function (page 31).
For example, if Steps A to D are
frequently used when you want to
program Steps A, B, C, D and E,
program Steps A to D using the
system macro. Then program Step E
in the Timer Macro adding to that
system macro.