Honeywell Miller Vi-Go Manual Series User Instruction Manual page 9

Connecting the Vi-Go Automatic Cable Sleeve
to Full-Body Harness
The Vi-Go Automatic Cable Sleeve is to be directly connected to the front attachment
point, designated for ladder climbing, of a Miller full-body harness using a Miller ap-
proved auto-locking carabiner or other Miller approved connector.
WARNING: The maximum length of the connector from the attachment
point on the harness to the cable must not exceed 9" (228mm).
1. Don a full-body harness according to the manufacturer's instructions. Check har-
ness to ensure that all straps are connected, buckles are secure, and harness is
adjusted to provide a snug fit.
body wear must be read and understood before using the equipment.]
2. Attach the cable sleeve to the front attachment point of the harness using a Miller
approved carabiner (or connector). Do not use connecting devices, such as a chain
assembly, quick link, or lanyard or substitute with non-Miller approved connectors.
3. Verify that the carabiner (or connector) keeper/gate is closed and locked.
Operating the Vi-Go Automatic Cable Sleeve
To ascend or descend, climb the ladder in normal fashion. The cable sleeve will follow
automatically.
Bypassing
Automatic Pass-
Through Cable
Guides: As the cable
sleeve encounters the
Intermediate Automatic
Pass-Through Cable
Guides, it will smoothly
bypass without manual
assistance.
Bypassing Manual Pass-Through Cable
Guides: To bypass Intermediate Manual Pass-
Through Cable Guides, snap the cable out of the
cable guide. Once the cable sleeve has passed
the cable guide, reconnect the cable into the cable
guide.
WARNING: DO NOT REMOVE CABLE
SLEEVE FROM CABLE TO PASS
INTERMEDIATE CABLE GUIDES.
When climbing is completed, remove the cable
sleeve and properly store according to the
maintenance instructions in this manual.
netzerotools.com
Us er Ins truc tion s - En gli s h
[NOTE: All instructions and warnings provided with the
8
netzerotools.com
◄ Whether climbing or descending,
no manual assistance
is required to bypass
AUTOMATIC Pass-Through
Cable Guides.
▲ When using the Vi-Go
Automatic Cable Sleeve with
MANUAL Pass-Through Cable
Guides, you must snap the cable
out of the cable guide to bypass.