Observe The Following Points In Canning - GE JP348 Use And Care Manual

circle are not recommended for most surface cooking.
However, when canning with water-bath or pressure
canner, larger-diameter pots may be used. This is
because boiling water temperatures (even under
pressure) are not harmful to the cooktop surfaces
surrounding the surface units.

Observe the Following Points in Canning

1. Be sure the canner fits over the center of the
surface unit. If your cooktop or its location does not
use smaller diameter pots for good canning results.
2. Flat-bottomed canners must be used. Do not use
canners with flanged or rippled bottoms (often
found in enamelware) because they don't make
contact with the surface units and take
a long
RIGHT
Flat-bottomed canners are required
for glass cooktops.
CAUTION:
Safe canning requires that harmful microorganisms
are destroyed and that the jars are sealed completely.
When canning foods in a water-bath canner, a gentle
but steady boil must be maintained for the required
time. When canning foods in a pressure canner, the
pressure must be maintained for the required time.
After you have adjusted the controls, it is very
important to make sure the prescribed boil or
pressure levels are maintained for the required time.
The cooktop surface units have temperature limiters
that prevent the glass cooktop from getting too hot.
If the bottom of your canner is not flat, the surface
unit can overheat, triggering the temperature limiter
to cycle the unit off for a time. This will stop the boil
or reduce the pressure in the canner.
Since you must make sure to process the canning jars
for the prescribed time, with no interruption in
processing time, you cannot can on any of the cooktop
surface units if your canner is not flat enough.
HOME CANNING T~S
WRONG
HOWEVER, DO NOT USE LARGE DIAMETER
CANNERS OR OTHER LARGE DIAMETER POTS
FOR FRYING OR BOILING FOODS OTHER
THAN WATER. Most syrup or sauce mixtures—and
all types of frying—cook at temperatures much higher
than boiling water. Such temperatures could
eventually harm the glass cooktop surfaces.
3. When canning, use recipes and procedures from
reputable sources. Reliable recipes and procedures
are available from the manufacturer of your canner;
manufacturers of glass jars for canning, such as
Ball and Kerr; and the United States Department of
Agriculture Extension Service.
4. Remember that canning is a process that generates
large amounts of steam: To a~oid burns f~om steam
or heat, be careful when canning.
NOTE: If your house has low voltage, canning may
take longe~ than expected, even tho~gh directions
have been carefully followed. The process time will
be shortened by:
(1) using a pressure canner, and
(2) starting with HOT tap water for fastest
heating of large quantities of water.
What is a Temperature Limiter?
Every halogen and radiant surface unit has a
Temperature Limiter. The Temperature Limiter
protects the glass-ceramic surface from getting
too hot.
The Temperature Limiter may cycle the units
off for a time if:
The pan boils dry.
The pan bottom is not flat.
The pan is off center.
There is no pan on the unit.
11