Making Calls; Receiving Calls; Busy User Pre-Emption (Bup) - Motorola MTM800 Feature User Manual

Making Calls

You are ready to place the call as required for the mode you
are in:
• press
• press and hold the PTT while talking, and release the PTT
while listening.
To dial a number for an outgoing call, enter the required
mode (Group, Private, Phone, or PABX) and use one of the
methods described on the following pages.
For more details on mode specific dialling methods, see the
relevant mode section in this guide.
Since the same numbers can be used in different modes for
various subscribers (if configured), be sure to make the calls
from the correct mode when entering a number through the
keypad. Pressing
carry the number typed to the next mode.

Receiving Calls

The MTM800 will automatically switch to the mode of the
incoming call. After the incoming call ends, the display
returns automatically to the mode it was in before the
incoming call arrived.
Your MTM800 will alert you of an incoming call depending on
the setting you selected in Tones menu option (see page 75).
During message editing, you will be alerted of an incoming
Group/Emergency Group/Broadcast Group Call if configured
by your Service Provider.

Busy User Pre-emption (BUP)

This feature is only available if set up by your Service Provider.
A console operator in the system might wish to call you while
you are in an on-going call (Private, Phone, PABX). The
16
to initiate the call and
or
to end the call.
while dealing a number will